With faceting machine off and Ceramic lap mounted on the machine, do the following:

(1)  With small bursts, spray 4 places around the lap with 50000 diamond spray.

(2)  With small bursts, spray 4 places with silicone based extender fluid (either Crystalube, Dia-Lube 20 or Raytech Thinner/Lubricant.

(3)  Work the mixture around entire lap with your fingers.

(4)  Wipe entire lap clean with a paper towel.  Lap is now ready to polish.

DO NOT USE WATER WHEN POLISHING WITH THIS LAP

When polishing action gets slow, first try adding more extender.   If that is not sufficient to get good polish action, add more diamond spray.     Remember, too much diamond spray will result in the powder balling up and scratching, so always be more generous with the extender than diamond spray.  Be patient. It may take a few uses to get optimum polishing efficiency.

Clean lap after each use with some extender and a paper towel.   Store securely in a clean container to prevent contamination.